Digicom ADSL router configuration

Here the steps you should follow to configure your Digicom ADSL router.

1. Open your browser and then type 192.168.1.1 in the address bar.
2. Put admin in both username & password.
3. Setup page will open & click on Network & then click on WAN.
4. Default Route Selection – Auto.
5. Click on Select Current ATM VC Table.
6. VPI-8
7. VCI-81
8. Encapsulation-LLC
9. Channel Mode-PPPoE
10. Enable NAPT
11. Enable IGMP
12. Type username & password (Provided by NTC).
13. Type – Continuous
14. Click on Modify.
15. Again click on Select Current ATM VC Table.
16. Click on Save in the bottom of the page (red color) if not Press on F11 & then click on Save.
17. Now you are ready to browse the Internet.